Concrete Pharmacy® SET Control®
Designed for use with Rapid Set® cement products and most other packaged hydraulic cements, SET Control® slows down the setting time of cement allowing you more time to place and finish your concrete, mortar, and grout materials. This extra time is often needed when making large or intricate placements (more than one cubic foot) of grout, mortar, or concrete. In warm weather when cement naturally sets faster, SET Control® works to slow down the hardening of the cement.
With Rapid Set® Mortar Mix (55-lb. bag), Grout (55-lb. bag), Concrete (60-lb. bag), and DOT Repair Mix (55-lb. bag), 1 packet of SET Control® will extend the setting time by about 20 minutes in normal conditions. A trial batch is recommended to fine-tune the setting time to match job-site conditions. Using SET Control® as recommended here does not reduce long-term strengths.
Dissolve SET Control® in the mixing water. Use enough SET Control® to achieve desired setting requirements. Follow product mixing instructions described on the package of the cement product. Do NOT exceed 4 packets per 50- to 60-lb. bag of Rapid Set®.
May cause skin, eye, and lung irritation. Avoid contact with skin, eyes, and clothing. Wash thoroughly after handling. Wear appropriate safety and protective equipment. DO NOT TAKE INTERNALLY. In case of contact, flush affected areas with water for 15 to 20 minutes. If irritation persists, seek medical attention. Wash contaminated clothing. Refer to Material Safety Data Sheet for more information.
Seller warrants this product is free from defects in material and workmanship and this warranty will be limited to replacement of the product. IT IS EXPRESSLY AGREED THAT THIS LIMITED WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES OF FITNESS AND MERCHANTABILITY.